Flame aerosol deposition Y3Al5O12:Yb 3+ , Er 3+ nanoparticles on monolayer MoS2 for broadening near-infrared photoelectroresponse

Abstract

Monolayer molybdenum disulfide (MoS2) is a two-dimensional material with a direct bandgap widely used in photoelectric detection. It exhibits excellent characteristics such as an ultra- high specific surface area, strong light interaction, and good carrier mobility. However, due to the bandgap limitation, monolayer MoS2 can only efficiently detect visible wavelengths less than 680 Combining lanthanide-doped upconversion nanoparticles with monolayer MoS2 to realize near- infrared (NIR) photodetection is a feasible strategy. Thus, Y3Al5O12:Yb 3+ , Er3+ up-conversion nanoparticles are deposited on the surface of a monolayer MoS2 by flame aerosol deposition (FAD), significantly extending their photoelectric response range to the near-infrared 980 nm. The Y3Al5O12:Yb 3+ , Er3+ nanoparticles synthesized by flame can achieve efficient up-conversion from near-infrared (~980 nm) to visible light (~450, ~550, ~650 nm). Therefore, the visible light can be subsequently absorbed by monolayer MoS2. The carefully designed Y3Al5O12:Yb 3+ , Er3+ /MoS2 photodetector shows strong responsivity and highly specific detectivity in the near-infrared spectrum. Under the bias voltage of 3 V and laser irradiation of 980 nm at 2.8 μW, the newly designed MoS2 device achieves a responsivity of 16.82 A/W and a specific detectivity of 1.47×10 12 Jones, as the traditional monolayer MoS2 usually responds to zero. This work can further expand the application of two-dimensional materials and their composites in near-infrared photoelectric detection